DISEqC 2.0

[bqlgepap]

Hi

Do i need to download something to my dreambox to get this switch to work? or can I just use the normal settings like the one for 4 lnb's like my switch is.

I am trying to setup a wave frontier toroidal t90, but when i try to find satellite it only searches on 1 lnb, even though i change satellite to get it to change lnb as well, or am I wrong here? (I know cause I tried holding my hand over the lnb, and it is the same one each time that gets my signal down). It does not seem like its setup for 4 lnbs.

My switch is a: EMP-centauri DISEqC 2.0 s4/1PNC-W1 (p.164-IW)

Edit: I found out that no mather what I do, it only searches on the signal from the lnb that is in switch port 1 (IN 1

 

[Hakon]

Hi

Do i need to download something to my dreambox to get this switch to work? or can I just use the normal settings like the one for 4 lnb's like my switch is.

I am trying to setup a wave frontier toroidal t90, but when i try to find satellite it only searches on 1 lnb, even though i change satellite to get it to change lnb as well, or am I wrong here? (I know cause I tried holding my hand over the lnb, and it is the same one each time that gets my signal down). It does not seem like its setup for 4 lnbs.

My switch is a: EMP-centauri DISEqC 2.0 s4/1PNC-W1 (p.164-IW)

Edit: I found out that no mather what I do, it only searches on the signal from the lnb that is in switch port 1 (IN 1

No need for download something to your box.
Port A is always active on a DiSEqC switch, that's why you can get signal from this LNB.
How has you done the settings in the menu in your Dreambox ?
You must activate all the port in the menu, and dedicate to the correct sat/LNB
Port A
Port B
Port C
Port D
As in my picture