BrianJ
Member
- Joined
- Jun 13, 2007
- Messages
- 7
- Reaction score
- 0
- Points
- 0
- Age
- 59
- My Satellite Setup
-
Technomate 1500CI+ Super
Gibertini 1M Dish
Moteck SG-2100 Motor
- My Location
- North East Ireland
Dish identification
- Thread starter BrianJ
- Start date
- Joined
- Jan 1, 2000
- Messages
- 35,621
- Reaction score
- 8,583
- Points
- 113
- Age
- 59
- Website
- www.sat-elite.uk
- My Satellite Setup
- A little less analogue, and a lot more crap.
- My Location
- UK
Got me stumped.
A lot of fibreglass dishes will have the manufacturer name embossed on the back of the reflector
What does the backplate look like ?
A lot of fibreglass dishes will have the manufacturer name embossed on the back of the reflector
What does the backplate look like ?
- Joined
- May 1, 1999
- Messages
- 38,299
- Reaction score
- 1,621
- Points
- 113
- My Satellite Setup
- Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
- My Location
- Berkshire
Sure I've seen one like that on the top of an outside broadcast van in the past.
pipino
Back from the dead
- Joined
- May 5, 2005
- Messages
- 913
- Reaction score
- 146
- Points
- 43
- Age
- 54
- My Satellite Setup
- 2X Channel Master 1.20 , 1X Channel Master1.80 ,1X Channel Master 2.40, Motorized Gibertini OP150 , Motorized Fibo MF90 ,, 70cm eliptical raven ..hirschmann fibre glass 1.20m
- My Location
- Comunidad Valenciana..ESPAÑA
can you post a foto of the back side of the dish?
BrianJ
Member
- Joined
- Jun 13, 2007
- Messages
- 7
- Reaction score
- 0
- Points
- 0
- Age
- 59
- My Satellite Setup
-
Technomate 1500CI+ Super
Gibertini 1M Dish
Moteck SG-2100 Motor
- My Location
- North East Ireland
Thanks for the replies guys.
I've checked all around the dish for any form of identification but there is nothing to be found.
This is a picture of the back bracket that screws on to the dish. It is missing its LNB arm but I might be able to make one. Also missing is the pole mount.
I've checked all around the dish for any form of identification but there is nothing to be found.
This is a picture of the back bracket that screws on to the dish. It is missing its LNB arm but I might be able to make one. Also missing is the pole mount.
