Dish not moving to other sats

student

Regular Member
Joined
Dec 3, 2004
Messages
91
Reaction score
0
Points
0
Age
50
My Satellite Setup
DM 7025+ 500GB, 85cm transparent dish on motor, 50Mbit line, Czech Link
My Location
East coast UK
Hi guys, I have Dreambox 7025 connected to a motor. I have reinstalled image (as Gemini stop supporting cams) to Nabilo Blackhole. My dish is “parked” at 23.5 and I have signal from there, but I can’t seam to move the dish to other satellites.

I think there is some setting in menu->set up->service searching->positioner setup , where I need to do something, but don’t remember what.

Also my "positioner storage" is only 1, I am assuming that’s 23.5

Any help to get my dish moving to other sats would be appreciated, many thanks
 

satelliteman

Administrator
Staff member
Joined
May 7, 2007
Messages
12,039
Reaction score
387
Points
83
My Satellite Setup
See signature
My Location
Northants, Midlands UK & Lanzarote, Canary Islands
You need to pan and save satellite positions in DiSEqC 1.2 mode or try USALs. If the latter, input your coordinates on the receiver.
 

student

Regular Member
Joined
Dec 3, 2004
Messages
91
Reaction score
0
Points
0
Age
50
My Satellite Setup
DM 7025+ 500GB, 85cm transparent dish on motor, 50Mbit line, Czech Link
My Location
East coast UK
When I check the tuner set up it says USALS, simple set up. My longitude and latitude is also in.

When I tell the receiver “go to 0” the dish does move, but I can’t seam to move it by going to say BBC1 on 28.2.

The receiver does not want to move the dish for some reason, I am sure I am missing something small, just not sure what…
 
Top