dish stopped moving

Messages
2
Likes
0
#1
my system is echostar 2510ip with jaeger 128 h2h, it has been working since installed when i go to move it says motor error checked reciever OK is there anything on jaeger i can checked thanxs
 

Llew

cerca trova...
Staff member
Messages
14,405
Likes
3,361
My Satellite Setup
Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
My Location
The Flatlands of East Anglia
#2
hi allan
'Motor Error ' on the Echostar usually means a disconnection between motor terminals and motor. Check motor cable run for continuity and wiring on motor (loose wires, corrosion etc.)
If you have an ohmmeter,disconnect the cable from the receiver and check for about 15 ohms between cable pair. If it's much lower than this, you could have a short on the motor.
Alternatively, the motor could be seized up.

Llew
 
Messages
2
Likes
0
#3
im checking cable this afternoon it was fine on thurday went to move it yesterday just keep saying motor error thanks for your reply
 
Top