Dreambox 7020-S Blues

Messages
20
Likes
0
#1
Hello,
how can I set my DB to a virgin state as I'm having problems with it,
I bought it second hand & its full of images, also will not be recognised through IP in comunication, I also tried serial port & got nothing.
one time only I managed to talk to it through "Total Commander" had to switch off box for some reason & when it was switched on again it lost contact, have tried lots of times to fix this but got nowhere, my brother has same box & his works Perfectly, can you help
regards,
The Wabbit:confused
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#3
Using a serial cable and Dreamup, flash it with something like a Gemini image, that should clear it of all of the other images and take it back to a workable state.
 

mhku

Super Moderator
Staff member
Messages
4,712
Likes
20
My Satellite Setup
TM Nano ~ sg2100
My Location
Midlands
#4
The serial port is only really for flashing a new image. To access it via IP address you need to use a CAT5 cable.

Have you read the Idiot's Guide?

And Welcome to the forum :)
 

dig deep

Prince of Birthdays
Staff member
Messages
7,125
Likes
208
My Satellite Setup
Dream7020 and AZ Elite and a few DM800
My Location
Sweden
#5
Perhaps all U need to do is set her up again.

Giving her a new IP addy and a fresh MAC adress

Could be nice to have a lot of images :)

If this fail, just read the guide
 
Top