got my matrix cam updated but what next??

T

tipsygent

Member
i have updated my matrix cam but still dont seem to unscramble any of the channels what next?i can go into the setup but what do i have to do ??

thanx tipsygent
 
Go into the common interface menu, it should say MR 1.055.

Go into Card information, it should say no card.

Go into Setup, and then Blocker, Nagravision EMU should be on, as with Irdeto.

In the Information section, it should say

H/W: 1.5
S/W: MR 1.055
Loader: 1.0
 
Are you trying this on Hispasat?
 
They will do, park it on Taquilla 2 and wait for a few minutes, it should autoupdate.
 
i have the v:1.60 and on the imformatiom scetion says h/w1.5 - s/w mr 1.60 loader 1.0 and i can get any channel working what can i do?????
 
Did you get the version 1.06 from the matrix cam site? There is a spoof version around, aslo which receiver are you using, there are some problems with Echostars.
 
yes from matrix cam site and using televes 7254 on hispasat what hapens its same times it open a channel but stop and dont go fron there and the other prob i have its that i cant access the cam menu to tray another upgrad any help????
 
To access the CAM menu, start up the receiver on a non-encrypted channel, should do it then.
 
When the CAM stalls, have you tried pulling it out and then pushing it back in to re-initialise?
 
yes mate the prob its whit the receiver as i tried the cam in another receiver a (kaon) and it works good so i thing i have to do a upgrad on may receiver what do u thing??? u know where to get firmware for televes?????
 
yes still not working on may receiver but had tray on a (kaon) and it worked fine so i thing its may rceiver that dosen't take this new soft 1.60 it was working at 75% with the v:1.55 the big prob now its that i cant do upgrad to 1.55 becouse i cant access the cam menu what do u thing its the best option for me?
 
Back
Top