tighbuidhe
Member
- Joined
- Aug 17, 2004
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Age
- 62
Some of you may have read my other thread and know that I am at present trying to fix my 'dead' actuator.
I was wondering, before I go too far and bust it completely, how and where I should be greasing the arm?
Having split it into two parts I started to unscrew the worm drive, do I......
1. Unscrew the worm fully out and pump grease down through the nut into the inner tube part?
(Is there anything likely to be attached to the worm inside the inner part eg. nut, bearing etc. I stopped unwinding to seek advice before I heard the sound of 'bits' falling off inside the tube)
or
2. Just slap some grease on the worm and work in and out a few times?
Also, the two thrust ball bearings a little grease, oil, WD40 or leave dry once they have been cleaned.
Any help or advice would be very much appreciated guys.
Many Thanks
I was wondering, before I go too far and bust it completely, how and where I should be greasing the arm?
Having split it into two parts I started to unscrew the worm drive, do I......
1. Unscrew the worm fully out and pump grease down through the nut into the inner tube part?
(Is there anything likely to be attached to the worm inside the inner part eg. nut, bearing etc. I stopped unwinding to seek advice before I heard the sound of 'bits' falling off inside the tube)
or
2. Just slap some grease on the worm and work in and out a few times?
Also, the two thrust ball bearings a little grease, oil, WD40 or leave dry once they have been cleaned.
Any help or advice would be very much appreciated guys.
Many Thanks