Vipersan
Emmett Browns Ghost
- Joined
- Jun 29, 2009
- Messages
- 10,918
- Reaction score
- 6,663
- Points
- 113
- Age
- 66
- My Satellite Setup
-
IP9000HD +
TD110 Dish and TD88 Dish in Tandem
66°East to 60°West.
AZbox PrmHD + OpnbxS9HD + Skybox + DrHD F15
2x VboxII AZ-EL
2 m+ Alcoa PF + BSC421 C-Band lnbf...
+SS2/TwHnS2-3200 pci/TBS6925 pci
1.5 Fortec Star -Gbox - HtoH Ku/Ka/C
- My Location
- UK
Heard a bit of a squeak last night as the H180 was running..
Needless to say panic set in ..
This morning took a positioner outside and hooked it up..
Everything I could tighten inside the motor was nipped up ..but those damned screws do loosen periodically..and this was happening long before I started modding..
I have a tube of Lithium grease which I have damned near emptied onto every moving part I can reach ..which sadly leaves a few I can't..
Not sure if it was particularly cold last night ..but only once did I hear a hint of a squeak when tracking extreme East to West and back again..this morning.
So my question for experts as this is not my area of expertise at all..
What is the best and most penetrating grease I can get ?
I need to get some into those tricky places so need some way to inject as well as smear ...
Can you guys help ?
Recommendations re greases and application would be most helpful.
rgds
VS
Needless to say panic set in ..
This morning took a positioner outside and hooked it up..
Everything I could tighten inside the motor was nipped up ..but those damned screws do loosen periodically..and this was happening long before I started modding..
I have a tube of Lithium grease which I have damned near emptied onto every moving part I can reach ..which sadly leaves a few I can't..
Not sure if it was particularly cold last night ..but only once did I hear a hint of a squeak when tracking extreme East to West and back again..this morning.
So my question for experts as this is not my area of expertise at all..
What is the best and most penetrating grease I can get ?
I need to get some into those tricky places so need some way to inject as well as smear ...
Can you guys help ?
Recommendations re greases and application would be most helpful.
rgds
VS