Help !!- Cam programming

Messages
4
Likes
0
#1
I have a Technomate 5500 DAPCI receiver with two CAM slots and the following cams which initialise as detailed below

Axas II - Dreamload

Matrix Cam Reloaded - Ucas 3.0

I don’t think the actual cams are preloaded with whatever software they require.
I also have a USB reader/writer (Infinity using version 1.0 software).



I would appreciate a few pointers on downloading and uploading software for both the Cams and the cards.

Any help much appreciated

Thanks
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
You should be able to use two fun 6 cards to program the Matrix reloaded and the Axxas cam can, I believe, also be converted to Matrix reloaded, but with the use of the CAS interface. There is more information on this in the Matrix reloaded and CAS interface forum.
 
Top