Help ProgDVB

Messages
20
Likes
0
My Satellite Setup
Manhattan ST 550, Nokia 9800s, 1.2mtr dish controlled by Uniden, SuperJack, Nokia 85cm motor driven SatScan dish. Plus Skystar2, and many other bits from analogue days.
My Location
Isle of Wight
#1
Hi,
When I try to enter a new channel, I enter freq. H or V and symbol rate, which I get from FeedHunters, I am then asked for SID TID and NIT, also I need to fill in the PID Table, the PID Table I can get from my Plaza on another dish. But this is a convoluted way of doing it, and I still don't get the other info needed to save a channel.
Chris.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
If you tick a transponder frequency, ProgDVB should simply search the transponder and add any channels to the list, or are you trying to add something which cannot be scanned?
 
Messages
20
Likes
0
My Satellite Setup
Manhattan ST 550, Nokia 9800s, 1.2mtr dish controlled by Uniden, SuperJack, Nokia 85cm motor driven SatScan dish. Plus Skystar2, and many other bits from analogue days.
My Location
Isle of Wight
#3
Hi Rolf
Thanks for the prompt reply, I thought I could bypass the scan by just inputting data, as I think I did with DVBViewer.
When I first had DVBViewer I registered and downloaded a comprehensive manual, thanks again for your advice, I will persevere.
Chris
 
Top