Help to Dreambox 500-s

R

Rumlesen

Member
My Satellite Setup
Dreambox
My Location
Denmark
Hi

Everytime i start my dreambox i have to do the following procedure.

Tap the blue bottom on the remote, then the blue panel pops up
Switch from common interface to betad(i think) at the top of the screen
Then select start/restart cam

Then it all works just fine.

But for some reason, i cant chose betad at the top anymore. Normally i just press the the right arrow on the remote, and it switches. But i can only chose common interfase now. It is like it is locked or something.
I have tryed my remote on another dreambox, and it works just fine there.

Anyone with a brilliant idea?

Sorry if my english is not the best

Frank
 
may be the last bin file loaded or a ecm... are you useing a programable sat card or are you cardless.. lastest bin that seems to be up here in USA is from3/20/09
rqcamd-1.17.zip for DREAMBOX for dish-n . perhaps do a factory reset and reload last good file, or a hard reboot by turning receiver off then back on again. hope this helps you out....
 
I would advise you reinstall the EMU (Soft cam) before doing anything as drastic as a factory reset.

If you have the box connected to the net, just download it from the addon's menu in the blue panel. Otherwise do a manual install.
 
Back
Top