Help with error message

In which case it needs loading, that is only the boot loader sofware.

where abouts are you Nordy?
 
Yes I know it. :)

What I mean is, you seem to have managed to delete ths operating software from the CAM, it isn't the end of the world, but it will need reloading.
 
It is available on all of the links i have given you above in the Matrix reloaded section.

To load it, you will need three funcard 5s or 2 funcard 6s.
 
No. That has been the cause of all your problems, did someone tell you that you could?
 
You need to do a bit of reading mate, you are trying to run before you have learnt to crawl.

Have a good read through the threads in the Matrix reloaded section, then have a read of the Cards and Programmers section.

When you've done that, I'll be happy to help.
 
okay but if i buy 2 funcards and update my matrix reloaded cam, then i just need to put the codes on right (keys).............?
 
Well yes, but i'm a tad concerned that you haven't really done any research.
 
LOL, I admire your tenacity, but it could cost you money. :)
 
You could try the sticky thread at the top of this forum.
 
okay i am starting to understand! some more questions if you don't mind.


1. When i have uploaded the .hex files using 2 or 3 funfiles, does the funfile card need to be in the cam when watching?

2. What do i use i titanium card for if i cannot transfer files like i can with fun cards?
 
Have you now got the firmware uploaded on the CAM?
 
no i have ordered 2 funcard 6's. Then i will update that with firmware ( is that just the latest version of mr?). And then do i upload files on titanium card? And then put key files in manualy with remote control?


Thanks for replying.
 
I would wait until you get the fun cards, then update the CAM with the latest file.

Once you have that working, then start with the titanium.
 
Back
Top