FatSat
Member
- Joined
- Mar 11, 2009
- Messages
- 5
- Reaction score
- 0
- Points
- 0
- Age
- 38
- My Satellite Setup
- lots
- My Location
- somerset
Same as my other listing only 4 months old with little use.
here is some info on the meter.
The HDTM Digital Terrestrial Meter V2 uses a similar platform as the HDSM and shows signal strength (R.F level), post BER and carrier noise.
The meter comes pre programmed with channels 21-69 and can hold an additional 32 muxes allowing for customising of the meter depending on your logistical position.
• Displays Signal Strength (R.F level) and Pre and Post BER together
• Displays numerical value for Post BER
• Displays digital carrier noise
• Fast and accurate Pre BER in real time for easy pointing of aerial via built in COFDM. Quality indicator
• 32 pre programmed transmitters (via website) or all channel step trough
• Audible tune-in, with back light
• Accurate RF level readings in the range of 35 dBuV to 75 dBuV +- 1 dB with over and under indicator
• 7 or 8 MHz channels
• 2K and 8 K mode
• Automatic constellation
• Output 5V Dc for DVB-T active antena
• VHF (band3) and UHF bands
• RF input range 167-862 MHz
• Input dynamic range -72dBm~-20dBm
• Input connector BNC. Input imp 75 ohms. Loop through
• Built in universal charger 100-240 V Ac/ 12 W. Intelligent charger (CE approved) with delta V delta T detection. Fast charge, then trickle
• Run time with full charge: Minimum 5 hours from 2.4 Ah NiMH battery
• Figure of 8 mains input connector. 2.1 mm Female PSU plug for external charge via supplied car charger
• Computer interface: Serial port (Com 1-4) for upgradeable software on transmitters.
• Supplied with leathercase, mains leads, programming lead, car lead, IEC to BNC adapter and 2 10 dB attenuators
Cash only, £200
here is some info on the meter.
The HDTM Digital Terrestrial Meter V2 uses a similar platform as the HDSM and shows signal strength (R.F level), post BER and carrier noise.
The meter comes pre programmed with channels 21-69 and can hold an additional 32 muxes allowing for customising of the meter depending on your logistical position.
• Displays Signal Strength (R.F level) and Pre and Post BER together
• Displays numerical value for Post BER
• Displays digital carrier noise
• Fast and accurate Pre BER in real time for easy pointing of aerial via built in COFDM. Quality indicator
• 32 pre programmed transmitters (via website) or all channel step trough
• Audible tune-in, with back light
• Accurate RF level readings in the range of 35 dBuV to 75 dBuV +- 1 dB with over and under indicator
• 7 or 8 MHz channels
• 2K and 8 K mode
• Automatic constellation
• Output 5V Dc for DVB-T active antena
• VHF (band3) and UHF bands
• RF input range 167-862 MHz
• Input dynamic range -72dBm~-20dBm
• Input connector BNC. Input imp 75 ohms. Loop through
• Built in universal charger 100-240 V Ac/ 12 W. Intelligent charger (CE approved) with delta V delta T detection. Fast charge, then trickle
• Run time with full charge: Minimum 5 hours from 2.4 Ah NiMH battery
• Figure of 8 mains input connector. 2.1 mm Female PSU plug for external charge via supplied car charger
• Computer interface: Serial port (Com 1-4) for upgradeable software on transmitters.
• Supplied with leathercase, mains leads, programming lead, car lead, IEC to BNC adapter and 2 10 dB attenuators
Cash only, £200