how do I get round this??

gandalfthegrey

Specialist Contributor
Messages
391
Likes
0
My Satellite Setup
Dreambox 800HD (clone)
Gibertini 85cm dish
4 way Diseqc switch........
linksys access point connected to Dreambox..
My Location
dublin,ireland
#1
Hi guys..
Finally got my HDCI 2000 set up and am impressed with the quality of HD....I am however experiencing a problem...I have a motorised dish which feeds one cable into a digital splitter...one feed goes into the Humax and one goes into my S*Y box, when I want to watch the humax I have to switch the S*Y box off at the mains because I keep getting the error "no or bad signal"....Anybody got ideas about how to overcome this??
cheers
gandalf
 

gandalfthegrey

Specialist Contributor
Messages
391
Likes
0
My Satellite Setup
Dreambox 800HD (clone)
Gibertini 85cm dish
4 way Diseqc switch........
linksys access point connected to Dreambox..
My Location
dublin,ireland
#3
Cheers Analogue....
Problem is the splitter is inside the house and the cable runs down the lenght of my back garden and thru a tiny hole iatthe front of the house..the "Boss" would throw a wobbly if I drilled another hole in the wall and ran a second cable thru the house..
gandalf
 

SatSearcher

Regular Member
Messages
215
Likes
110
My Satellite Setup
1m orbital dish with 0.1 Technomate LNB. TBS 6903 & TBS 5925 Card & Octagon SF4008. 39E-55W.
My Location
West Yorkshire
#4
I have the exact same set-up as you, the way i deal with the problem is to go into the secret installer menu on the Sly box (thats services, 4,01 select,1) which brings you to the LNB menu, then turn off the LNB power, this will give you full signal to your Humax. Just do the same procedure again when you want to use your Sly box again.
 
Messages
7
Likes
0
My Satellite Setup
plaza350,dreambox7000,triax110,
My Location
Holland
#5
do what i do get an A/B switch and switch back and forth between the sky box and the humax.

TWAG
 
Top