Rec45
Member
- Joined
- Dec 29, 2010
- Messages
- 13
- Reaction score
- 0
- Points
- 0
- Age
- 78
- My Satellite Setup
- Motor/Fortec/Octagon
- My Location
- 51.6N / 0.4E
Hi
I tried it on few satellites on my system. I cannot add new channels from already existing transponders. Strong signal is present, manual scan goes through but search does not bring the new channels which i knew they are there. I cannot even add new radio channels to the existing transponder where i had installed only FTA TVs from. Is the channel list uploaded from the usb be the hindering further additions ?
I need advise if anyone with had same problem. At this stage i am looking for a quick fix rather than re start the STB. I had put so much effort editing 6 satellites on it.
This list is saved in usb , but i am thinking even if i do a factory reset installing same file back on will not be a short cut.
Fortec is updated with loader 1.5 and s/w version1.30. I went through the manual twice to no avail. Any ideas please?
Thanks
I tried it on few satellites on my system. I cannot add new channels from already existing transponders. Strong signal is present, manual scan goes through but search does not bring the new channels which i knew they are there. I cannot even add new radio channels to the existing transponder where i had installed only FTA TVs from. Is the channel list uploaded from the usb be the hindering further additions ?
I need advise if anyone with had same problem. At this stage i am looking for a quick fix rather than re start the STB. I had put so much effort editing 6 satellites on it.
This list is saved in usb , but i am thinking even if i do a factory reset installing same file back on will not be a short cut.
Fortec is updated with loader 1.5 and s/w version1.30. I went through the manual twice to no avail. Any ideas please?
Thanks