Advice Needed Jack end bearing

Manikm909

Manikm909

Small'ish Dish Man
My Satellite Setup
Channel Master 1.8M on Edision MIO 4K & GTMEDIA Combo, and CM1.2M on Octagon SF8008
My Location
Kent, UK
ive noticed that the bearing "ring" at the end of my 36" jack has come out - do they just press in? seems an odd one to me.
is this a common fault?
 
wrong jack Jack, its the one that drives dish east and west - not up and down.
 
Manikm909 said:
ive noticed that the bearing "ring" at the end of my 36" jack has come out - do they just press in? seems an odd one to me.
is this a common fault?
Click to expand...

I,v had this happen with - Superjacks - ... if its not damaged , de - grease it and push it back in after applying some superglue :-)

I had one completely break up ... and had to create a replacement using filler paste ....

end jack.webp
 
Manikm909 said:
wrong jack Jack, its the one that drives dish east and west - not up and down.
Click to expand...
I didn't mention whch one, the issue is the same, the bearing will loosen and fall out unless certain actuators are under near continuous compression.
 
ive managed to press it all back together using some grips - all good, fitted bigger washers too so it shouldnt happen again (he says)
 
Back
Top