statalite
Member
- Joined
- Nov 3, 2009
- Messages
- 766
- Reaction score
- 314
- Points
- 63
- My Satellite Setup
-
Nova-HD-S2, Dr HD D15, Free sat V7S, Free sat v8 finder V-71HD
Zone 1 @ 28.2°E
Zone 2 @ 19.2°E with 28.2°E and 13.0°E
Channel Master 1.0m (to be setup)
Channel Master 1.2m (to be setup)
SMR 1224
- My Location
- UK Midlands
I have realised I am missing a section of steel pipe used to brace the underside of a 1224, which a threaded bolt goes through and uses this pipe as a shieth as well.
The said 1224 isn't in commission yet but wish to get one of these before I start.
I have done some measurements and the holes it needs to match are 12mm, and looks to be 106mm in length.
Anyone know if it's possible to get a ready made replacement? (very unlikely I know).
I have been looking on the famous auction site and can see the correct diameter but not length in stainless steel but it would have to be reduced in length from those supplied. Am I looking at the wrong supplier for my requirement? Stainless steel would appear difficult to cut? I don't have the tools.
The said 1224 isn't in commission yet but wish to get one of these before I start.
I have done some measurements and the holes it needs to match are 12mm, and looks to be 106mm in length.
Anyone know if it's possible to get a ready made replacement? (very unlikely I know).
I have been looking on the famous auction site and can see the correct diameter but not length in stainless steel but it would have to be reduced in length from those supplied. Am I looking at the wrong supplier for my requirement? Stainless steel would appear difficult to cut? I don't have the tools.