borderfox
Member
- Joined
- Jun 5, 2006
- Messages
- 25
- Reaction score
- 0
- Points
- 0
- Age
- 41
- My Satellite Setup
-
Skystar 2 PCI card;
Dreambox 7020S
2x Eagle Linux Boxes
Moteck motorised setup with 88cm dish.
Multi LNB bracket
- My Location
- Ireland
Just looking for some help from current users of this Sat Meter. Bought it recently but only got the chance to play with it earlier this week. I loaded the most recent dataset on there. Then started to use it on my multi lnb dish. It works fine on the easier to get sats -but for 1*W and 16*E, I'm finding it impossible to fine tune in. I end up using a receiver and tv - for fine tuning.
These two sats are weak in my location using a T90 dish - but when tweaked, I can just about get the important channels on them.
I thought that this meter should show the transponder that I'm tuning in as well - or allow me to select different transponders??? It just gives me the option of tuning in the chosen sat for either V or H. For both of these sats, Its showing 0 for signal quality. On the receiver, I can get them to very very low SNR level (ie a couple of hundred).
Any feedback on how to use meter effectively would be appreciated!
These two sats are weak in my location using a T90 dish - but when tweaked, I can just about get the important channels on them.
I thought that this meter should show the transponder that I'm tuning in as well - or allow me to select different transponders??? It just gives me the option of tuning in the chosen sat for either V or H. For both of these sats, Its showing 0 for signal quality. On the receiver, I can get them to very very low SNR level (ie a couple of hundred).
Any feedback on how to use meter effectively would be appreciated!