Jim Bob
Member
- Joined
- Apr 8, 2010
- Messages
- 7
- Reaction score
- 1
- Points
- 3
- Age
- 45
- My Satellite Setup
- DM500s
- My Location
- Spain
I have just installed an Ikusi multiswitch 2 in 16 out.
I have used Technomate receivers with diseqc 1 and 2 setup.
The receivers are working but they lose signal.
When you select a channel it shows no signal but if you select a different channel the signal will then kick in and you are able to return to the previous channel no problem.
I know there's a few variables here but does anyone recognise this problem?
I have checked the signals on the satellites and they are fine.
The cabling is old and not in the best condition but it was working with the 1 in multiswitch that we have replaced.
Any suggestions please ?
I have used Technomate receivers with diseqc 1 and 2 setup.
The receivers are working but they lose signal.
When you select a channel it shows no signal but if you select a different channel the signal will then kick in and you are able to return to the previous channel no problem.
I know there's a few variables here but does anyone recognise this problem?
I have checked the signals on the satellites and they are fine.
The cabling is old and not in the best condition but it was working with the 1 in multiswitch that we have replaced.
Any suggestions please ?
Last edited by a moderator: