matrix revolution cam

Messages
2
Likes
0
My Location
glasgow
#1
hi everyone. posted earlier but no replies. i have just purchased and received the following: technomate 55000dapci receiver+disc 1.2 motor+matrix revolution cam + cas2cam programmer. thus done so far -downloaded software. +firmware -erased cam and written 2.19 firmware to it verified it and exited program.(take it this is what u do) now what -what do i do with cam now, to see other channels apart from move dish (not installed it yet) please help as completely new to this.
 

Llew

cerca trova...
Staff member
Messages
14,484
Likes
3,416
My Satellite Setup
Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
My Location
The Flatlands of East Anglia
#2
cambis9 said:
hi everyone. posted earlier but no replies. i have just purchased and received the following: technomate 55000dapci receiver+disc 1.2 motor+matrix revolution cam + cas2cam programmer. thus done so far -downloaded software. +firmware -erased cam and written 2.19 firmware to it verified it and exited program.(take it this is what u do) now what -what do i do with cam now, to see other channels apart from move dish (not installed it yet) please help as completely new to this.
Hi cambis
That's the easiest bit. Just slide it ino your receiver.
Now install your dish and come back here for any help you need.

Llew
 
Top