mp3.5 (serial) firmware?

Messages
8
Likes
0
#1
Does anyone know if my 2 year old (elvis) MP3.5 serial programmer with 1.5 firmware will perform all programming operations on a titanium card?(using multiprog and titanium updater)
if not will it only either
a. program hex files if the correct operating system is already on the card
b. revise operating system

Latest firmware from Ad-teknik, for mp3.5 serial, is version 1.10 .Is this required for full programming of titanium card?
thanks
phil
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,697
Likes
1,285
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
A two year old Elvis should be fine, I think that we have the latest Titanium progger for the Elvis in our utilities section.
 
Messages
8
Likes
0
#3
Software is not a problem downloaded that and it is straiaghtforward. It is if the firmware will handle titanium cards. I dont want to be sending it back to Ad-Teknik if iI dont have to.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,697
Likes
1,285
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
Sorry, that's what I mean, should be fine as long as you can set it to phoenix mode 3.58Mhz
 
Messages
8
Likes
0
#5
Rolfw
Thanks for clarifying, that info is just what I wanted.
It does go into phoenix mode 3.58.
No excuses now, will have to pick up a titanium card tomorrow.
Thanks
Phil
 
Top