mr/topfield

Messages
26
Likes
0
#1
hi everyone
i want to buy a matrix reloaded cam but i want to know if it is going to work fine with my topfield 3000 ci pro receiver or not.
in addition my receiver is programmed with the allcam patch software will i have to change this software or upgrade it? in other words does the allcam software(firmware) prevents the matrix rel. cam from working in my receiver?
thanks in advance
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,676
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
It should work wisebird, but I haven't seen any information directly relating to your model, it certainly works with the PVR models. You may have to experiment with which CAM slot you use though.

I would certainly advise scouring some of the other forums for compatibility issues, I guess that you could always go back to original software version.
 
Messages
26
Likes
0
#3
hey i got the MR cam and thank goodness it works
but there is a problem still exists i can't get the ucas menu under the ci menu in the receiver
what could be the problem
regards
wisebird
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,676
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
Can you get it when the Matrix is not inserted?
 
Top