My setup

T

thevic

Member
My Satellite Setup
Tm6900 HD Combo super+
Tm1500 CS Super +
1M motorised dish
My Location
Kent coast
This is my sat set up, at the moment my 1m dish is locted at the end of the garden but my range of sats is restricted by trees, so i am moving it onto a small section of flat roof on the house, the roof is covered in lead so i dont want to make holes in it hence all the brackets. Any suggestions how to improve the set up would be more than welcome.
 

Attachments

  • DSCF1511.webp
    DSCF1511.webp
    457.2 KB · Views: 101
  • DSCF1510.webp
    DSCF1510.webp
    446.6 KB · Views: 90
  • DSCF1512.webp
    DSCF1512.webp
    446.4 KB · Views: 87
  • DSCF1509.webp
    DSCF1509.webp
    447.5 KB · Views: 93
  • DSCF1508.webp
    DSCF1508.webp
    420.6 KB · Views: 84
Nice set up.

A non penetrating roof mount might be the ticket if there's space.
 
thevic said:
Any suggestions how to improve the set up would be more than welcome.
Click to expand...

Use a cable tie to secure the cable from the motor to the LNB to the pole a few i8nches below the motor - Repeated movement across the arc can result in the F connector at the motor end gradually coming loose. By securing the cable to the pole this cannot happen.


But a very nice installation :)
 
satelliteman said:
Nice set up.

A non penetrating roof mount might be the ticket if there's space.
Click to expand...

Thanks satelliteman
I thought about it but its is a fairly narrow area and thought the mount together with any ballast may restrict the rainfall run off, as it has the rainfall of three roofs on it.
 
Tivù said:
Use a cable tie to secure the cable from the motor to the LNB to the pole a few i8nches below the motor - Repeated movement across the arc can result in the F connector at the motor end gradually coming loose. By securing the cable to the pole this cannot happen.


But a very nice installation :)
Click to expand...

Thanks Tivù, i will go out and do it now
 
Back
Top