New system

R

romchik

Member
My Satellite Setup
Technomate TM 5400 CI+ USB Super
My Location
UK
Hi guys i still did not finish to repair the house so i am now trying to choose system.
1) Echostar PVR-5020 HDD
2) Triax TD 110
3) Invacom 0.3 lnb
4) Moteck SG2100 DiSEqC 1.2
Wich one LNB do i need for triax dish from this two
[size=+1]SNH-031 Universal Single LNB 0.3dB Horn[/size] or
[size=-1][size=+1]SNF-031 Universal Single LNB 0.3dB C120[/size][/size]
[size=-1]Could you please tell me is this system is going to be a good choise or may be i need to change somthing?[/size]
[size=-1]Thank you[/size]
[size=-1][size=-1]
[/size]
Roman
[/size]
 
You need the SNH-031 Invacom with integrated feedhorn.

snh-wlrg.jpg


Don't know the receiver (but it sounds nice!) but I would say that your intended dish is on the upper limit for the relatively puny diseqc motor (though the SG2100 is one of the better diseqc motors).

STICK
 
Thank you.As far as i understood the other one does not have a feed- horn but is more expensive-why is that? You have told that Moteck motor is on it's limit can you advice different one?
Sorry i am new to satellites.:confused:
Can i run TV and Satellite cable together?
Thank you again
Roman
 
Any DiseqC motor will be on its limit with a 1.1m dish, particularly if it is in an exposed position.

C120 LNBs are nearly always more expensive that the ones with the integral feedhorns, probably slightly more expensive to make.
 
I've seen the info on the Echo 5020 and it looks impressive. Is it available to buy yet?
 
romchik said:
Thank you Guys. Cuold you recomend the best DiSEqC 1.2 motor?
Click to expand...

My favourite is the Moteck SG-2100, but there are obviously some i haven't tried. :)
 
SatCritics gave a good write up for the Motk SG-2100. I have one and it swings my 1.25m Aluminium dish about AOK, the Fortec Star FS2100 is the same motor just has different label on it.
 
* Aforrester
Is that 125cm a Gibbertini you're using by any chance??

L
 
Thank you guys. I probably stick with Moteck SG2100 DiSEqC 1.2
Roman
 
Thanks for the link romchik, it looks a quality machine which is to be expected from Echostar. I'd like to have seen a 36v positioner but that's my only negative. Easy to get over though.
 
* Lancelot

yes m8, i've pm'd you
 
does anybody know why (at) shows up as (*) on this forum?
 
The * is a recent change. - last month or so I think. Chris the head guy upgraded the forum recently, so perhaps it sneaked through then
 
Back
Top