compufunk
Regular Member
- Joined
- May 7, 2008
- Messages
- 1,658
- Reaction score
- 1
- Points
- 38
- My Satellite Setup
-
DM 600-S, VU+ Duo,
Moteck SG2100, Fracarro Penta 85 dish, LG LH3000 42" TV + some computers
- My Location
- NW, Ireland
Hi All,
I'm not sure if I have the right section for this thread, If not please move mods,
I was wondering if anyone can make any sense of this error message, As far as I can tell its only happening when I try to scan / blindscan 9° E, Other sats are fine. The error pops up instantaniously, too quickly for the box to have had time to try to scan anything, its the same whether I try to scan while pointed at that sat or while pointed at another and expecting the system to move the motor around.
When I did a multi sat scan during initial setup I managed to scan in 130 services.
When I try to view any channels on this sat, the dreambox takes a long time to lock on to anything, When I change channels on that sat, it keeps saying its moving the motor then eventually displays the channel,
Signal quality is 70% - 80% on any transponders I checked with zero bit error rate.
Regards
C
I'm not sure if I have the right section for this thread, If not please move mods,
I was wondering if anyone can make any sense of this error message, As far as I can tell its only happening when I try to scan / blindscan 9° E, Other sats are fine. The error pops up instantaniously, too quickly for the box to have had time to try to scan anything, its the same whether I try to scan while pointed at that sat or while pointed at another and expecting the system to move the motor around.
When I did a multi sat scan during initial setup I managed to scan in 130 services.
When I try to view any channels on this sat, the dreambox takes a long time to lock on to anything, When I change channels on that sat, it keeps saying its moving the motor then eventually displays the channel,
Signal quality is 70% - 80% on any transponders I checked with zero bit error rate.
Regards
C