Hi all,
Got a DM800 clone. It was a cable version, so I ordered a brand new Rev M DVB-S2 tuner and installed.
Configured my tuner in setup and connected to my satellite meter then to my LNB (with the intention of aligning). Noticed there was no power in the meter so got my multimeter and checked the end of the coax cable... 0V. So I plugged in a 12 inch jump cable from tuner and used the multimeter again, this time it reads about 0.3V. Sometimes I check it and it goes up to about 3V, but nothing near the 13/18 is should be.
I'm really stuck here... Don't know what I've done wrong
. Any help appreciated!
Cheers
Got a DM800 clone. It was a cable version, so I ordered a brand new Rev M DVB-S2 tuner and installed.
Configured my tuner in setup and connected to my satellite meter then to my LNB (with the intention of aligning). Noticed there was no power in the meter so got my multimeter and checked the end of the coax cable... 0V. So I plugged in a 12 inch jump cable from tuner and used the multimeter again, this time it reads about 0.3V. Sometimes I check it and it goes up to about 3V, but nothing near the 13/18 is should be.
I'm really stuck here... Don't know what I've done wrong
Cheers