Problem with my cas interface programmer

Gladiator8387

Regular Member
Messages
78
Likes
0
My Location
CypRuS
#1
I have a Magic Module... And a cas interface programmer (cas interface studio 2.1). The problem is that when i press write the file (e.g. MR1.10) the programmer starts writing on the cam. 2 minutes later.. it speeds up and from 5xxx it goes to 20xxx and doesn't write anything between this space.

This results in having some channels still scrambled.

Can anyone help me plzzzz??? Saturday today.. FOOTBALL :((((
PS: I used many different files..the same thing happens

Thank you
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
What are you writing to the CAM?
 
Messages
2
Likes
0
#4
Hey Gladiator,


Umm. Do you have the CAS dummy programmer. I'm trying to get the circuit diagram for it or a good picture of the front and back of it.
Could you help me there?

Regards,
Vlad
 

Gladiator8387

Regular Member
Messages
78
Likes
0
My Location
CypRuS
#5
Vlada said:
Hey Gladiator,


Umm. Do you have the CAS dummy programmer. I'm trying to get the circuit diagram for it or a good picture of the front and back of it.
Could you help me there?

Regards,
Vlad
Emm... Although it goes fast that section.. the result is the same..i asked duolabs and they told me is absolutely normal.. so.. no need for worrying..
 
Top