Problems with gold card

gov400

gov400

Regular Member
My Satellite Setup
Dreambox 7020s
Gibertini OP120 Dish
STAB HH120 MOTOR
My Location
London
I am new to this sattelite programming biz. A mate gave me 3 blank gold wafer cards and a dynamite programmer. He told me using this kit i can watch the footy on multivision on Saturday. I own a Mondeal 7500 with embedded Viaccess. I programmed the card with the SATWARRIORS.viaccess files for gold card. But when placed in reciever it comes up with "CHECK THE CARD". Please help
 
what do u mean when u say "earse the card before loading the file" I formatted it on the dynamite software.
 
It's a long time since I loaded a gold card, so just to refresh my mind I have just loaded a an AU (auto updating) Mach1 gold card file. After popping it into my receiver it worked fine. Even though it had out of date keys the AU found and reset to up to date keys within 30 sec. All TPS + MV work fine.

To load the file I did have to earse to old PIC and HEX that had been loaded since the last time I used the card.

Get a file from the DEN, a Mach1 .
 
Toecutter's den, see Nobbly's Big Links section.
 
Just to clear up Govs trouble with the card

The gold cards have two chips, and one has to be flashed with a set up programme for it to load up the main chip for the codes/key data. Once its programmed then the set up file is cleared down to allow the card to operate in a receiver.

Most programmers will have this file in their databank, but you may find you have to download it from one of the sites


Additionally the Multivision/TPS channels will not clear in a separate Viaccess cam with goldcard, you have to have a receiver with embedded viaccess, (and not an all in one embedded solution)
 
Back
Top