Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
satellite switching problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JonnytheKid" data-source="post: 55696" data-attributes="member: 181057"><p>Hello everyone,</p><p></p><p>Thanks to Llew and rolfw for prior advice.</p><p></p><p>However, I was a little hasty in saying everything was sorted. My problem is this:</p><p></p><p>if my receiver (Echostar) is on Hotbird, and I switch to Astra1, then I get a "no signal" message, until I go into the "LNB setting" menu. I have Hotbird as LNB 1, and so on the LNB menu I set Astra1 as LNB 2. I press the "OK" button, and I get a "stored" message, but if I change channel, it (mysteriously) changes itself back to LNB 1, so to get Astra 1 back again, I must go back into the LNB setting menu and change it back to LNB 2 and so on, and so on... But shouldn't the sat switching button do all this by itself?</p><p></p><p>I'm not sure I've explained this very well. I have written down the monoblock specs and the LNB settings menu if that would help.</p><p></p><p>Jonny</p></blockquote><p></p>
[QUOTE="JonnytheKid, post: 55696, member: 181057"] Hello everyone, Thanks to Llew and rolfw for prior advice. However, I was a little hasty in saying everything was sorted. My problem is this: if my receiver (Echostar) is on Hotbird, and I switch to Astra1, then I get a "no signal" message, until I go into the "LNB setting" menu. I have Hotbird as LNB 1, and so on the LNB menu I set Astra1 as LNB 2. I press the "OK" button, and I get a "stored" message, but if I change channel, it (mysteriously) changes itself back to LNB 1, so to get Astra 1 back again, I must go back into the LNB setting menu and change it back to LNB 2 and so on, and so on... But shouldn't the sat switching button do all this by itself? I'm not sure I've explained this very well. I have written down the monoblock specs and the LNB settings menu if that would help. Jonny [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
satellite switching problem
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top