Satlook miicro charger Volt and ampage please

[chavo]

Hi all. i am trying to charge my satlook micro G2 and the charger i thought was the right one isnt doing jack! no lights no nothing.

The charger i thought was correct has an output value of 13.8v 3000mA 50-60Hz 1.5A

Can someone tell me the correct values so i can find a new charger, this one is clearly wrong!

Thanks fellas

 

[craignigel]

Emiter had to send me a new mains charger from Sweden, as the one supplied with my new Micro G2 "blew up" after I first plugged it in. The replacement was a different model to the original.
Hope that helps

Model PS481BD1Y3000S
OUTPUT 13.8V 3000mA

 

[chavo]

Thanks mate thats a massive help. how did you go about getting yours changed? i have just emailed them but i know they are overseas so these things can take time.... lots of time! plus i cant find my car charger to test it to confirm that the charger is the fault and not the meter.

Thanks again for that mate, really appreciate it.

 

[satelliteman]

Attached image.

 

[Channel Hopper]

You have to verify the positive of the charger is the centre pin.

Using an incorrect charger will almost certainly damage the battery inside.

 

[craignigel]

I sent an email to Emitor's Sales Engineer because my meter was new and had only just arrived from a supplier in Germany. He told me that Emitor would replace the faulty power unit directly when I emailed him about the problem. So I followed that up with an email to Emitor and sent the photo of the damaged unit and a copy of the invoice - just to be sure!!

Their Sales Engineer telephoned me within minutes and said he would post a new power supply to me. It arrived just under a week later. I found Emitor to be very helpful.
This is where I found their email addresses (I picked a English speaker)., but you probably have this link.

__http://www.emitor.se/extra/pod/?id=83&module_instance=1&action=pod_show&navid=83

Hope that helps

Nigel