I know this is old reciever but what error code Lo3 means? I do something about sat settings and get this error. now everything is blocked and I cant do anything with this reciever. Is it possible to hard reset it or something similar ? is there hard reset techniwue to do this? I hope there are good people that will help me With regards
SIMBA problem
- Thread starter janeku
- Start date
- My Satellite Setup
- A little less analogue, and a lot more crap.
- My Location
- UK
The upgrade used to be on the Hotbird satellite, and downloading was achieved by disconnecting the power and reconnection at the same time as pressing the front panel power button. I am not sure if the firmware is still available on satellite.
- My Satellite Setup
- Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
- My Location
- The Flatlands of East Anglia
Can't do any upgrades while stuck on Lo3. A boot flash is required (not trivial - an RJ45 to RS232 interface will be needed, plus a bootloader).
I made my own interface, but you can buy one from _http://www.electronicasuiza.com and go to Jtag/Seasons Interface section.
Bootloaders and other Simba files can be found here -
_http://www.aston-team.net/
I haven't done anything with a Simba for years, but may still have some info somewhere if you get stuck.
Llew
I made my own interface, but you can buy one from _http://www.electronicasuiza.com and go to Jtag/Seasons Interface section.
Bootloaders and other Simba files can be found here -
_http://www.aston-team.net/
I haven't done anything with a Simba for years, but may still have some info somewhere if you get stuck.
Llew