T
Tom
Guest
Using Chipcat 2.3 (easiest)
Check configuration settings and make sure the clock is set to 6,0Mhz
Select pic/wafer card from the pull down menu.
1)Load the hex files from your hard drive
a)Select load 1 (the pic file).
b)Select load 2 the (eeprom file).
Follow the pop up prompts at each stage
2)Select write, set to picprog mode 2 (switch OUT) and insert card with chip down.
3)Switch to mouse mode 0 (switch IN).
4)Switch to picprog mode [2] (switch OUT), once this stage is completed the card is programmed.
Check configuration settings and make sure the clock is set to 6,0Mhz
Select pic/wafer card from the pull down menu.
1)Load the hex files from your hard drive
a)Select load 1 (the pic file).
b)Select load 2 the (eeprom file).
Follow the pop up prompts at each stage
2)Select write, set to picprog mode 2 (switch OUT) and insert card with chip down.
3)Switch to mouse mode 0 (switch IN).
4)Switch to picprog mode [2] (switch OUT), once this stage is completed the card is programmed.