Sky plus HD remote control

Zorba

Zorba

Regular Member
My Satellite Setup
3m(28.2E),1.5m(19.2E.13E,10E),1m (4W ,7W)1m (?).diseqc 10,sky plus,VU+,telergy iptv.
Satlook nit colour + Horizon hdsm.
My Location
Limassol, Sunny Cyprus
A sky plus remote control can also work the Sky plus HD box but the HD remote cannot work the sky plus box. I read somewhere that the HD remote can be programmed to work the Sky plus box. Can someone please tell me how to do it ?
 
Try pressing TV, then holding blue button plus select until the LED flashes twice, then press either 0, 1 or 2 and then select and Sky, you'll have to experiment as to which number works.
 
Tried all those numbers ,then the rest but no luck.
 
Try with the yellow button instead.
 
Tried the yellow, then the other colours. Still no luck.
 
Sky remotes - reprogram standard to operate Sky+ or HD and vice versa

As the title says how to reprogram Sky remotes (and reset them to factory defaults which can cure non operating remotes. All remotes have at least 8 different modes (HD have 12). Obviously standard remotes do not have the Sky+ function buttons but recordings can be played from the planner by highlighting and pressing "Select" twice and stopped by pressing "Backup" - no pause, FF, Rewind or Record buttons (but recordings can be set from pressing "record" on the box.

For most remotes Version 4 and later (white label inside battery cover)
1 Press "TV"
2 Press and hold "Select" and "Yellow" together until red led in remote end flashes twice (On HD remotes "Select" and "i" together) - if it doesn't flash twice then remote cannot be reprogrammed (clone or too old)
3 Press "0" to operate standard box, "1" for Sky+ and on HD remotes "2" for HD - remotes in Sky+ mode will normally control HD boxes as well
4 Press "Select" - red led should flash twice
5 Press "Sky" and away you go
Click to expand...
If the above does not work you either have a non genuine remote or it is faulty. Note on HD remotes it is "Select" and "i" and NOT blue or yellow.
 
davemurgtroyd said:
If the above does not work you either have a non genuine remote or it is faulty. Note on HD remotes it is "Select" and "i" and NOT blue or yellow.
Click to expand...
Thanks Dave. It was the "select and i" and 1 that did it ,first go. @Rolfw thanks anyway :-)
 
Back
Top