Spray painting a 1.2 channel master

J

jpsr

Regular Member
My Satellite Setup
1.2 channel master, cm polar mount, 12 inch actuator, Andrews feedhorn, Inverto lnb, Superjack positioner, Dreambox dm 500s, Protek 9600ip, 1m channel master with black ultra & 1m gibertini with technomate twin output lnb on astra 1/2, TM 5200 & 1000
My Location
Mullingar, Ireland
I am going to spray paint my channel master dish,
I was looking in halfords at grey spray paint as after cleaning the dish for ages there are still stains that wont come off.

A guy in the hardware store said he painted his fibreglass boat and the paint started to peel off, will it happen the dish.

What is the best cans of spray for the job.
 
Have you tried a solution of bleach, i bunged the holes up and filled the dish up then left it to soak for an hour, i also scrubbed with a stiff brush, i found this worked for me. you could also try kitchen surface cleaner.
 
I did'nt try bleach.
Its more the back of the dish, there was green stains which i removed, but there is faded black stains that wont come off.
 
Hi

Just make sure that you give it a good clean with hot soap and water , then rub it over with a pan scrub , ( you can get them from any store , they are a small ball of wire , I am sure that your wife / mother will have one under the sink ) then make sure it is completely dry , then get a can of , Black Satin finish Enamel spray paint , and give it 3 or 4 light coats , thats it I done mine about 4 years ago and it still looks like new , I used spray can from Wilkingson ( WILKO ) there is usually one in most town centres .
 
Back
Top