• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

strong 4375 update

Messages
1
Likes
0
My Location
stockport
#1
when updating software on the 4375 by pc does the reciever have to be in stand by or switch on to a channel have tried to up grade using rs232 lead and nothing seems to happen i have tried for over 2 hours but the loader just keeps flashing please wait and the status bar does not move
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,620
Likes
1,254
My Satellite Setup
See signature
My Location
Berkshire
#2
I seem to remember that with my Hyundai, the receiver starts in standby, you start the PC loader software and then switch on the receiver.
 

PRINCE

Regular Member
Messages
138
Likes
0
My Location
uh::
#3
Hi ,

You need to switch the receiver off from the mains.Hold down the menu and exit button and then plug the receiver back into the mains.The display would show 0000, connect the null modem cable and press upload firmware. The progress indicator should start immediately if it doesn't, that means you have the wrong cable.You need a cross null modem cable which you can get from satellite dealer not from electronic shop.

Regards

Prince
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,620
Likes
1,254
My Satellite Setup
See signature
My Location
Berkshire
#4
LOL, another one of these simple procedures for three armed people. :)
 

Channel Hopper

Suffering fools just so you don't have to
Staff member
Messages
23,944
Likes
4,994
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South East
#5
My guess is that you have the wrong cable