OldBen
Mad Scientist
- Joined
- Jul 29, 2005
- Messages
- 249
- Reaction score
- 4
- Points
- 18
- Age
- 47
- My Satellite Setup
- Triax TD110 with multi LNB 28.5E, 23.5E, 19E, 13E Inverto Black Ultra's (Black Premium on 28.5) into multiswitch. VU+ Duo. Emitor Satlook Lite meter.(Retired: Technomate 1500CI+, Moteck DG2100 DisEqC Motor, Metronic 85cm Clear Dish, Invacom 0.3db LNB
- My Location
- UK
Ok somewhere I saw a thread that putting a washer on the back of a TD110 arm to space it slightly increased signal by positioning the LNB slightly better in the focal point of the dish, only now I can't find it? Anyone done this or point me to the thread? Washer between arm and dish bracket where wingnut is?
Also, even though I drilled the arm and installed the extra bolt that came with the multilnb holder, I seem to have quite a bit of play in the arm still (up/down), do these arms need to be braced with some extra supports, or do I just need to tighten the bolts at the back of the dish that are through the bracket and arm more? (worried about too much bending thin bracket/arm pieces).
Also, even though I drilled the arm and installed the extra bolt that came with the multilnb holder, I seem to have quite a bit of play in the arm still (up/down), do these arms need to be braced with some extra supports, or do I just need to tighten the bolts at the back of the dish that are through the bracket and arm more? (worried about too much bending thin bracket/arm pieces).