In the Diseq1.2 Motor menu, when I select 'Move' (East or West) the dish always goes to its E or W limit rather than moving only while the key is pressed. With the key held down it reverts to 'Stop' aftyer a second or so but, as I say, the dish continues to move to its limit. Selwcting 'Ok@ with 'Stop' displayed doesn't stop it. Can anyone throw any light on this - is there some way of stopping the dish ?
Technomate TM 5500 DACI - Problem with 'Move' Command
- Thread starter somesat
- Start date
updatelee
Member
- My Satellite Setup
- TBS5925/6925/5980/5922/6903/6522/6908/6983, DVBSky S960, DD Cine S2
Prof 7301/7500/8000, Genpix Skywalker-1, Skystar 2 Express HD
Hauppauge 950Q/955Q/Aero/Aero-m, Kworld 330U/435v3/445v3, MyGica T230C
- My Location
- Edmonton, Alberta, Canada
are you sure the right command is getting sent to the dish ? does your software tell you the diseqc cmd being sent ?
Lazarus
Retired Moderator
- My Satellite Setup
- 80cm Motorised.
Several small Dishes.
Much else.
- My Location
- North York Moors
Is this a recent problem?
ie Was it working properly originally?
If so, then perhaps you try to recall what, if any, changes you may have made recently and/or could try resetting the Motor if it's one which permits this via a pinhole in the bottom of the casing.
What Motor is it, exactly?
ie Was it working properly originally?
If so, then perhaps you try to recall what, if any, changes you may have made recently and/or could try resetting the Motor if it's one which permits this via a pinhole in the bottom of the casing.
What Motor is it, exactly?