Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
Satellite Systems - What to Buy - What to install
Titanium ASC1 DiSEqC Positioner
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cmoorr" data-source="post: 1076498" data-attributes="member: 414161"><p>Hi </p><p></p><p>Photos of the new transformer setup.</p><p></p><p>An update on my older ASC1 unit.</p><p></p><p>I did some output tests and under minimal load I was getting 29v AC and under heavy load 20V ac. mains transformer output was 25v AC from the .8a tap and 27v AC from the 4amp tap.</p><p></p><p>On removal of the small switch mode board it was noted there was PCB track burns under one of the heat sink regulators.</p><p></p><p>I am sending the PCB back to titanium for service.</p><p></p><p>My new titanium ASC1 works fine under load with the motor output not dropping below 29v AC</p><p></p><p>.Also the front display has been updated and there is now no issue virwing the display from any angle. I have also been told the new display is available in a green or blue backlight.</p></blockquote><p></p>
[QUOTE="cmoorr, post: 1076498, member: 414161"] Hi Photos of the new transformer setup. An update on my older ASC1 unit. I did some output tests and under minimal load I was getting 29v AC and under heavy load 20V ac. mains transformer output was 25v AC from the .8a tap and 27v AC from the 4amp tap. On removal of the small switch mode board it was noted there was PCB track burns under one of the heat sink regulators. I am sending the PCB back to titanium for service. My new titanium ASC1 works fine under load with the motor output not dropping below 29v AC .Also the front display has been updated and there is now no issue virwing the display from any angle. I have also been told the new display is available in a green or blue backlight. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
Satellite Systems - What to Buy - What to install
Titanium ASC1 DiSEqC Positioner
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top