Total xcam newbie

W

wingman182

Member
Messages
8
Likes
0
My Satellite Setup
XCAM
CAS INTERFACE 2
#1
Dear all,

I am new to satellite programing and just got a xcam with cas interface 2 with add on. I have put the xcam to virgin mode on block 2 and installed the firmware, must I again put the xcam in virgin mode on block 14 to update the softkeys???

many thanks

wingman.

ps> I have another xcam and the blocks are messed up, can I resue it with the cas programer. my reciever locks up everytime with the xcam istalled.
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,726
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
No, just load the softcamkey.

You should be able to reload the non-working CAM with the CAS2.
 
W

wingman182

Member
Messages
8
Likes
0
My Satellite Setup
XCAM
CAS INTERFACE 2
#3
rolfw said:
No, just load the softcamkey.

You should be able to reload the non-working CAM with the CAS2.

Thx Rolf,

Do I pug the xcam into the cas main unit with the dummy card inside??
 
Top