A
Archive7
Guest
This morning my VU+ Solo SE V2 doesn't want to boot.
I read somewhere that I might need to reflash the image that I have already VTi
I am not too keen on reflashing as I will need to set everything again from scratch.
Didn't backup anything.
My main concern is my recordings on the HDD. Last time I lost all the recordings while trying to mount the disk and that was only after a week, now I have a lot more material.
Is there any other way that can make the box reboot without reflashing?
I have disconnected it from power in the meantime, until I hear your advices.
Thanks.
I read somewhere that I might need to reflash the image that I have already VTi
I am not too keen on reflashing as I will need to set everything again from scratch.
Didn't backup anything.
My main concern is my recordings on the HDD. Last time I lost all the recordings while trying to mount the disk and that was only after a week, now I have a lot more material.
Is there any other way that can make the box reboot without reflashing?
I have disconnected it from power in the meantime, until I hear your advices.
Thanks.