vx micro can this still be used

Messages
2
Likes
0
My Location
warrington
#1
hello everybody
i have a vx micro programmer
that came with 2nd hand reciever i recently bought, it has no cables or leads my question is is it of any practical use or am i best buying
the very latest programmer also are the funcard 4, pink, gold , silver cards
that came with it worth keeping any advice would be appreciated
 

loftyj

Regular Member
Messages
247
Likes
0
#2
Mine sits in a box in my desk along with a number of cards, not much use for the latest cards on the market. Modern cams like Dynamite only require the correct Drivers and software to load them and then work without a card in them.
Read Dynamite USB programmer lower down page.
 

Llew

cerca trova...
Staff member
Messages
14,487
Likes
3,418
My Satellite Setup
Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
My Location
The Flatlands of East Anglia
#3
rjbrom said:
hello everybody
i have a vx micro programmer
that came with 2nd hand reciever i recently bought, it has no cables or leads my question is is it of any practical use or am i best buying
the very latest programmer also are the funcard 4, pink, gold , silver cards
that came with it worth keeping any advice would be appreciated
You can still use your VXMicro and Funcard4 with 6-in-1 files, of which there are plenty around. You'll need a 9V PSU and an RS232 serial cable.

Go to :-

_http://www.vxtools.com/downloads.htm

for software for the Multi.

Llew
 

Llew

cerca trova...
Staff member
Messages
14,487
Likes
3,418
My Satellite Setup
Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
My Location
The Flatlands of East Anglia
#5
loftyj said:
Hi Llew
When I enquired from VX tools was told Micro will not update to multi
Sorry I meant the program is OK for the VXMicro
 
Top