Weird problem with motor

Chr0nik

Chr0nik

Member
Messages
41
Likes
0
My Satellite Setup
TM-9100 Linux receiver,
TM-2100a Rotor,
80cm Dish (43w to 42e)
My Location
Brixton, London
#1
Hi everybody!

Yesterday night I was able to move the motor to other satellites but since this morning I can only get Thor 1W and when I try to move the dish, it does not move at all.. I dunno what's going on or what to do.

Can anybody help?

My receiver is a Technomate 1000D Super, my motor is a stab hh90 and my dish is a 80cm dish.

thanks!
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,726
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Have you tried unplugging the receiver at the mains and rebooting? Are you actually getting a signal/picture on 1W?
 
Chr0nik

Chr0nik

Member
Messages
41
Likes
0
My Satellite Setup
TM-9100 Linux receiver,
TM-2100a Rotor,
80cm Dish (43w to 42e)
My Location
Brixton, London
#3
I'm getting sound and image from thor 1w.
 
Channel Hopper

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,982
Likes
5,885
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#4
Sounds like you may have a failed motor.

It does happen, not often, but it does happen.

Is it under warranty, and was the work guaranteed ?
 
BGonaSTICK

BGonaSTICK

Retired Moderator
Messages
5,145
Likes
0
My Satellite Setup
Dreambox 7000, Skystar2
My Location
Brighton
#5
CH may be right... your motor's been acting really weird since you got it IIRC.
Could also be your Techno of course.

Have you re-flashed it?

Have you overwritten the motor's internal satellite table perhaps?

You could try resetting the motor to factory default settings... (think you can do that on the Stab).
 
Chr0nik

Chr0nik

Member
Messages
41
Likes
0
My Satellite Setup
TM-9100 Linux receiver,
TM-2100a Rotor,
80cm Dish (43w to 42e)
My Location
Brixton, London
#6
BGonaSTICK said:
CH may be right... your motor's been acting really weird since you got it IIRC.
Could also be your Techno of course.

Have you re-flashed it?

Have you overwritten the motor's internal satellite table perhaps?

You could try resetting the motor to factory default settings... (think you can do that on the Stab).
how can i do that on a hh90?
 
Top