X-Cam 1.03 update

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,233
Likes
5,632
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#1
Ive just repaired a customers receiver, and this was in the slot.

It still gives him the French ABSat channels on 13 East, but not much else.

I can access the individual standards and provider lines, but there are very few that would clear.

Has anyone successfully updated a 1.03 X-Cam to a later version (Orion ?), and could I use a serial programmer card from a Magic Module (DreamMedia) to do it ?
 

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Messages
25,233
Likes
5,632
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK South
#3
Thanks, but there is something different about X-Cams that have 1.03 (or earlier) to the later ones.

Will carry on searching.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,700
Likes
1,287
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#4
Long time since I loaded one of those, but I think that you can update the operating version.
 
Top