X-Cam 1.03 update

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Joined
Jan 1, 2000
Messages
35,538
Reaction score
8,554
Points
113
Age
59
Website
www.sat-elite.uk
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK
Ive just repaired a customers receiver, and this was in the slot.

It still gives him the French ABSat channels on 13 East, but not much else.

I can access the individual standards and provider lines, but there are very few that would clear.

Has anyone successfully updated a 1.03 X-Cam to a later version (Orion ?), and could I use a serial programmer card from a Magic Module (DreamMedia) to do it ?
 

CB65

Regular Member
Joined
Apr 2, 2004
Messages
39
Reaction score
0
Points
0
Age
63
My Satellite Setup
Technomate 5400 CI+ USB, 70CM Motorised dish, XCAM, Infinity USB Pheonix
Panasonic Freeview
My Location
Dorset England

Channel Hopper

Suffering fools, so you don't have to.
Staff member
Joined
Jan 1, 2000
Messages
35,538
Reaction score
8,554
Points
113
Age
59
Website
www.sat-elite.uk
My Satellite Setup
A little less analogue, and a lot more crap.
My Location
UK
Thanks, but there is something different about X-Cams that have 1.03 (or earlier) to the later ones.

Will carry on searching.
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
Long time since I loaded one of those, but I think that you can update the operating version.
 
Top