X Cam Pcmcia Programming

Messages
5
Likes
0
#1
Hi everybody,
I've just bought an X CAM firmware version 1.080 and have it installed into my toshiba laptop pcmcia working under WINXP.
The CAM seems to be installed properly but when I try to program it using xcpcmci loader software, I receove the following message:

Xcam0 not respond [05419368]

and it doesn't program anything. What can it be wrong, does exist any other software or procedure to upgrade an XCAM via PCMCIA port only?
Thanks U All.
 
Messages
1
Likes
0
My Satellite Setup
satellite encription
#4
Hello every one,
kindly i need the xcam drivers, if any one can help me with that i will be very appreciate.

Regards,

Hilal.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#5
Follow the link above, all of the loaders are there.
 

RyokoFanUK

Regular Member
Messages
41
Likes
0
#6
You cant update the XCam via PCMCIA unless it has been previously patched. You know when it has been patched as it will display "-p" next to its firmware version in the CI menu in your receiver.
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#7
Ah yes I seem to remember installing that, had forgotten doing it. :)
 
Top