Xilinx for MR

Messages
29
Likes
0
My Satellite Setup
Digiquest 6700 embedded ucas rcvr /hotbird and Astra
My Location
Spain/southern
#1
I tried to update my new MR with 1.18 and now it does work in reciever.
the details look like this.....CAM Connected
Xilinx XC9536XL CPLD Version 4 detected
Manufacturer ID: 0xC2
Device ID: 0x0049
Flash: MACRONIX MX29LV160BTC
does this look correct???
 
Messages
1
Likes
0
My Satellite Setup
MANHATTAN MATRIX
WINDOWS XP PRO
#2
I have a matrix REBORN with the same specs as yours. I can program it and put it in my MANHATTAN STARLIGHT MX receiver ,it initialises but will not unscramble channels.Programmed with Zcas 1.0 using cas3 put in my receiver and it seemed to work,Free channels worked and when i went to a scrambled channel it switched and asked me to put a card in the cam.
However, I programmed some fun card 6's with zcas2ucas firmware and these would not load in the cam.
I have tried programming with mrb3.08,3.09, and 3.10 and the cam programs and can be initialised in receiver but it just does not unscramble any programme
AS ANYONE ANY IDEAS?????-PLEASE
 
Messages
29
Likes
0
My Satellite Setup
Digiquest 6700 embedded ucas rcvr /hotbird and Astra
My Location
Spain/southern
#3
Hey I finally got my cam to take what was happening. I was not writing the files to my cam, just loading them. Hey if you have a cas 3 then there is no reason to use cards. Mr Hopper taught me that one (dude on this forum) What you will have to due is change the cam keys, with your remote or cards. Have you tried this?
 
Top