zeus programmer help

Messages
3
Likes
0
#1
ok this is my last ditch effort to program a funcard 6 with a zeus that i have had for a while, if no joy i will get a adtek multi , just had a bit of time to kill and dusted it off

have posted before elsewhere but not many people seem to have the zeus

trying to use cardwriter 2.08

keeps asking me to change to amtel mode 4

comes up with sync errors also

can anyone point me in the right direction to a good idiots guide or indeed offer any advice at all

green led working
red led lights up and goes when trying to read

any advice on how to write

cheers
 

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,671
Likes
1,279
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Have a look at www.duwgati.com, there are some tutorials on the different card writing packages. :)
 
Messages
3
Likes
0
#5
tried again.


keeps asking to switch programmer to amtel mode then comes up with sync errors?

think the zeus is goosed
 
Top