I got a 10 feet dish, Pansat 3500s and a VBox (from DSM) to move my dish.
All works great, but as I start saving sats and moving the dish true the receiver (using the VBox) there is a time when the VBox will loose exact position it should go to for satellites. Then I have to manually move it...
Lancelot, hi, thanks for responding.
I am very new on this and I got the dish free. SO I changed something like the Feedhorn and LNBs got the Chapparral Coroto II c/ku. I also noticed the arm was bad and bought a new one. But I bought the 24 and the old one was an 18. Do you think that is...
I got my actuator yesterday and installed it todya in my BUD 10 feet mesh.
I want to try to do the last and hardest part of the installation which is align the dish to get the arc ok.
I know I have to point the dish to my due south satellite. I am at latitud 28, longitud 82.5. My due south...
OK, I have read a lot about this part of my project (setting a C band dish).
I have a 10 feet mesh dish. With several peoples help from this fourum I am ready to install a mover tomorrow and try to align it.
I am using a PanSat 3500s receiver and a VBox.
I just want to get some extra ideas...
I do not know what make it is. I got it for free. I will check tomorrow in the morning, but I think 18.8 as you said should be ok.
Now, I have some dents but they are not super dents. I tried to fix them but if I put my hand on one side the dent will go to the other. So I just left it going...
I was measuring my 10 feet mesh dish Depth, and need someone to clarify something for me, please.
To measure it, I ran a cord from one side of the dish to another. Then I used a measure tape and measure from the inside center of the dish to the cable going across. Exactly from the middle of...
ok, thanks, I will go up and remove the feedhorn and use a pen to create the arrow looking at the picture I got from the flyer and when I get it install again, I will make that arrow point to the ground at 90 degrees (that is what the flyer says, paoint arrow to Polar Axis).
Likvid, THANKS a...
I am looking at the flyer picture. It says the arrow should be pointing to the polar axis. Does that means the arrow has to point to the ground?? Like pararell to my pole?
But I do not have the pointing arrow. I do not know where it is, maybe I dropped it by mistake. now what do I do, I do not have a pointing arrow???? What can I do now???
Hi, I am an new to this forum and TOTALLY new to C band dish.
I got a 10 feet mesh dish for free. I decided to change the C band only feedhorn and lnb that came with it to a C/Ku so I could get more channels.
I installed the dish on a 17 feet pole next to my house (it was a lot of work) but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.