Recent content by SLZ

Hi, I use skynet .92 and .93D with my skystar2, driver 4.4.0.0. I have pointed my dish to "Express AM22", 53 E, and everything is OK except one thing! On the frequency, 11481 H 41250, I see that DISCONTINUTY counter permanently goes up and practically affects my long files (and most of the...

I am writing this final post for those who may encounter the same problem. If you are sure that your dish, lnb and other equipment are 100%ok and all software settings are correct, then you can proceed to test your hardware (Skystar). Because most of the components on this card are SMD (surface...

Guys, I soldered out the mentioned coil and soldered what ever 1mH coils available I had, guess what!? Nothing! then I soldered 2 wires to the bases of the coil and tested near 30 coils!!!!! nothing happend to high band, finally I opened shell of original coil but wires seemed to be ok and no...

Dear Rolf and Orthoclipse; Thank you very much for the care you have taken to solve my problem. I am going to change coil right now and I have found almost a same coil in a broken computer-power-supply. I will keep you informed about the results. Sincerely:)

Thanks alot for you attention guys, I think final solution is purchasing another one, the bad point is that I live in Iran where even owning ss2 is considers a crime!!

Swithc 11700 ok, power: checked, Lof1: 9750, LOF2: 10600, KU band. I dont know what on earth happend to this poor skystar! I even installed my card to my brothers computer who has the same card, his card functions good but mine is useless at high band:( :-cry1

I got it, you mean "local ocillator" of the lnb which is 10600 mhz for high band and swithc 11700. Anyway, the settings are ok, I checked them again. Why there is no crying smili at this forum?:( :(

ProgDVB ver: 4.71.5 and DVBviewer, both act the same. I usually test it with "fast sat finder" which shows 0% signal on High band! The card was ok at the time I bought it and I received more that 1200 channels on hotbird:rolleyes:, then I pointed my dish to UtilsatW3 in order to do...

Sorry, I have no idea about that. The last thing I have decided to do is to get someone solder out EEprom of the card and reprogram it! I have even downloaded the datasheet of eeprom!:( :( but finding a suitable programmer is really an issue!:(

Transition figure? would you explain more? is it something like, say a radio button in softwares which enable/disable 22khz?

Dear Rolf; My "Starsat" receiver receives all channels using this LNB and dish!:confused: (and shows signal quality of above 50%).:(

11919 Mhz is the highest tunable frequency (on hotbird). 22khz is on (I tested it using a variety of tuner programs like "b2c2 tunner control" and "progDVB"). I wish somebody would tell me how to make additional checks on 22khz tone, including a way to test it; without using osiloscope. Thanks.

Hi guys, problem: Skystar2 Rev.2.6D doesn't tune to high band frequency (frequencies like 12597) but all other functions are 100% OK (it was working perfect at the time of purchase)! Othe info: Tuner 14/18V ok, LNB ok, cable ok, everything ok and checked. Driver Ver: 4.3.2 and I have checked...