Recent content by snapperoonie

I did a similar project a few years back and it's still fine never had to adjust anything since the day I put it up. Dish Upgrade

Bit late I know but these guy's have a good selection http://www.barenco.co.uk/hardware-clamps-brackets/v-u-bolts

Thanks for the info guys, I have now downloaded EBS pro and am trying to get to grips with it.

I have recently purchased the above card and wondered what software you guys are using. So far I've been playing around with Crazyscan and streaming to VLCplayer after loading FFD show for codecs, I've tried Progdvb , Dvbviewer and Dvbdream and am leaning towards the latter as the others seem to...

TBH I didn't know this was even possible my first thoughts were to use it on my laptop via an A/B switch. I do however like the idea of using it in conjunction with my Duo and to that end I have been reading around a bit but can't find a basic tutorial so if anyone could point me in the...

I'm beginning to get the urge for a new toy and quite fancy a TBS5925 to have a go at some feed hunting, my question is how do I best integrate tis into my present system as listed on the left?

Just a another case of Hare today Tagine tomorrow then :-ohcrap

Narrowboats Waiting At Dadford's Wharfe Just found these I took last year whilst out for a walk in my local area.

This one must have had a heavy night 'cause he never budged for the 5 mins or so I was watching him from the opposite bank

I went for a walk along my local canal this morning and spotted this fellow

One thing you haven't mentioned, if you are using usals you will need to put your new co-ordinates into your receiver.

@CJ I forgot to mention that you say your walls are solid brick, I assume by this you mean that the bricks are of the non perforated type used in older houses, if this is indeed the case and you do go down the resin route then you won't need the plastic mesh sleeves. There's plenty of technical...

Personally I would go for chemical every time as I love the idea of no expansion forces on the bricks, just do do your research and make sure you get the right resin and studs for the job, after all if chemical anchors are good enough to fix crush barriers in sports stadiums then I'm sure they...

Check out MiniTool Partition Wizard, it's free and like st1 says just make sure you back up first.

Photoshop tutorial here